Telit Wireless Solutions ME910C1-WW - Response Format - V






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page30of233

Q - Quiet Result Codes
Note: After issuing either ATQ1 or ATQ2 every information text transmitted in
response to commands is not affected
Note: if parameter is omitted, the command has the same behaviour of ATQ0
Example
After issuing ATQ1 or ATQ2
AT+CGACT=?
+CGACT: (0-1) nothing is appended to the response
Reference
V25ter
Response Format - V
V - Response Format
ATV[<n>]
Set command determines the contents of the header and trailer transmitted with result
codes and information responses. It also determines if result codes are transmitted in a
numeric form or an alphanumeric form (see [§3.2.4 Information Responses And
Result Codes] for the table of result codes).
Parameter:
<n>
0 - limited headers and trailers and numeric format of result codes
information responses
<text><CR><LF>
result codes
<numeric code><CR>
1 - full headers and trailers and verbose format of result codes (factory default)
information responses
<CR><LF>
<text><CR><LF>
result codes
<CR><LF>
<verbose code><CR><LF>
Note: the <text> portion of information responses is not affected by this setting.
Note: if parameter is omitted, the command has the same behaviour of ATV0
Reference
V25ter