Telit Wireless Solutions ME910C1-WW - GPRS Data Volume - #GDATAVOL






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page196of233

#FRWL - Firewall Setup
If criteria matched, then the packet is accepted and the rule scan is finished; if
criteria not matched for an
y
chain the packet silentl
y
dropped.
AT#FRWL?
Read command reports the list of all ACCEPT chain rules registered in the
Firewall settings in the format:
#FRWL: <ip_addr>,<net_mask>
#FRWL: <ip_addr>,<net_mask>
….
OK
AT#FRWL=?
Test command returns the allowed values for parameter <action>.
Example
Let assume we want to accept connections only from our devices which are on the
IP addresses ranging from
197.158.1.1 to 197.158.255.255
We need to add the following chain to the firewall:
AT#FRWL=1,"197.158.1.1","255.255.0.0"
OK
GPRS Data Volume - #GDATAVOL
#GDATAVOL - GPRS Data Volume
AT#GDATAVOL=
[<mode>]
Execution command reports, for every active PDP context, the amount of data the
last GPRS session received and transmitted, or it will report the total amount of
data received and transmitted during all past GPRS sessions, since last reset.
Parameter:
<mode>
0 - it resets the GPRS data counter for the all the available PDP contexts (1-16)
1 - it reports the last GPRS session data counter for the all the set PDP contexts
(i.e. all the PDP contexts with APN parameter set using +CGDCONT), in the
format:
#GDATAVOL: <cidn>,<totn>,<sentn>,<receivedn>[<CR><LF>
#GDATAVOL: <cidm>,<totm>,<sentm>,<receivedm>[…]]
where:
<cidn> - PDP context identifier
1..16 - numeric parameter which specifies a particular PDP context definition
<totn> - number of bytes either received or transmitted in the last GPRS
session for <cidn> PDP context;
<sentn> - number of bytes transmitted in the last GPRS session for <cidn>
PDP context;
<receivedn> - number of bytes received in the last GPRS session for <cidn>
PDP context;