Telit Wireless Solutions ME910C1-WW - FTP Append Extended

To Next Page

To Previous Page



AT Commands Reference Guide

80529ST10815A Rev.2– 2017-09-14



ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page190of233



Text row number 1 * 11111111111111111111111111 * Text row number 2 *

22222222222222222222222222 * Text row number 3 *

33333333333333333333333333 * Text row number 4 *

44444444444444444444444444 *

Text row number 5 * 55555555555555555555555555 *

Text row number 6 * 66666666666666666666666666 * Text row number 7 *

77777777777777777777777777 *

Text row number 8 * 888888888888888888888

OK AT#FTPRECV=200

#FTPRECV:200

88888 *

Text row number 9 * 99999999999999999999999999 *

Text row number 10 * AAAAAAAAAAAAAAAAAAAAAAAAAA* Text row

number 11 * BBBBBBBBBBBBBBBBBBBBBBBBBBBB *

Text row number 12 * CCCCCCCCCCCCCCCC

Note: to check when you have received complete file it’s possible to use

AT#FTPGETPKT read command:

AT#FTPGETPKT?

#FTPGETPKT:sample.txt,0,1

(you will get <eof> set to 1)

FTP Append Extended - #FTPAPPEXT

#FTPAPPEXT - FTP Append Extended

AT#FTPAPPEXT=

[,<eof>]

This command permits to send data on a FTP data port while the module is in

command mode.

FTP data port has to be previously opened through #FTPPUT (or #FTPAPP) with

<connMode> parameter set to command mode connection.

Parameters:

<bytestosend> - number of bytes to be sent

1..1500

<eof> - data port closure

Telit Wireless Solutions ME910C1-WW - FTP Append Extended - #FTPAPPEXT