Telit Wireless Solutions ME910C1-WW - Edrx Read Dynamic Parameters - +CEDRXRDP






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page103of233

+CEDRXS - eDRX setting
parameters information element in 3GPP TS 24.008 Table 10.5.5.32/3GPP
TS 24.008.
AT+CEDRXS?
Read command returns the current settings for each defined value of <AcT-
type>.
AT+CEDRXS=? Test command returns the supported <mode>s and the value ranges for the
access technology and the requested eDRX value as compound values.
Reference 3GPP TS 27.007
eDRX read dynamic parameters - +CEDRXRDP
+CEDRXRDP - eDRX read dynamic parameters
AT+CEDRXRDP
Execution command returns <AcT-type>, <Requested_eDRX_value>,
<NW-provided_eDRX_value> and <Paging_time_window> if eDRX is
used for the cell that the MS is currently registered to, in the format:
+CEDRXP: <AcT-type>[,<Requested_eDRX_value>[,<NW-
provided_eDRX_value>[,<Paging_time_window>]]]
If the cell that the MS is currently registered to is not using eDRX, <AcT-
type>=0 is returned.
Parameter:
<AcT-type>: type of access technology.
0 - Access technology is not using eDRX
1 – CAT M1
2 - GSM (A/Gb mode)
3 - UTRAN (Iu mode)
4 - E-UTRAN (WB-S1 mode)
5 - E-UTRAN (NB-S1 mode)
<Requested_eDRX_value>: string type; half a byte in a 4 bit format. The
eDRX value refers to bit 4 to 1 of octet 3 of the Extended DRX parameters
information element (see subclause 10.5.5.32 of 3GPP TS 24.008). For the
coding and the value range, see Extended DRX parameters information
element in 3GPP TS 24.008, Table 10.5.5.32/3GPP TS 24.008.
<NW-provided_eDRX_value>: string type; half a byte in a 4 bit format. The
eDRX value refers to bit 4 to 1 of octet 3 of the Extended DRX parameters
information element (see subclause 10.5.5.32 of 3GPP TS 24.008). For the