Telit Wireless Solutions ME910C1-WW - Page 223






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page223of233

8 - PDSM Ended session because of Error condition
9 - User ended the session
10 - End key pressed from UI
11 - Network Session was ended
12 - Timeout (viz., for GPS Search)
13 - Conflicting request for session and level of privacy
14 - Could not connect to the Network
15 - Error in Fix
16 - Reject from PDE
17 - Ending session due to TC exit
18 - Ending session due to E911 call
19 - Added protocol specific error type
20 - Ending because BS info is stale
21 - VX lcs agent auth fail
22 - Unknown System Error
23 - Unsupported Service
24 - Subscription Violation
25 - The desired fix method failed
26 - Antenna switch
27 - No fix reported due to no tx confirmation rcvd
28 - Network indicated a Normal ending of the session
29 - No error specified by the network
30 - No resources left on the network
31 - Position server not available
32 - Network reported an unsupported version of protocol
33 - MOLR System failure
34 - MOLR Unexpected data value
35 - MOLR Data missing
36 - MOLR Facility Not Supported
37 - MOLR Subscription Violation
38 - MOLR Position Method Failure
39 - MOLR Undefined
Note: Errors [1-32] can be marked as non – abortable, using
<error_mask>, so session will continue until stopped
manually by user.
EXCEPTIONS: Errors [9-12] are non – abortable by default,
and error mask does not affect them.
AT$GPSSLSR?
Read command returns the current settings, in the format:
$GPSSLSR:
<transport_protocol>[,<pos_mode>[,<client_id>,<clientid_type
>[,<mlc_number>,<mlcnumber_type>[,<interval>
[,<service_type_id>
[,<pseudonym_indicator>][,<error_mask>]]]]]]
AT$GPSSLSR=? $GPSSLSR: (0-2),(0-3),(64),(0,1),(64),(0,1),(0-7200),(0-255),(0,1)
,(0-4294967295)