Telit Wireless Solutions ME910C1-WW - Page 79






AT Commands Reference Guide
80529ST10815A Rev.2– 2017-09-14

ReproductionforbiddenwithoutTelitCommunicationsS.p.A.writtenauthorization‐AllRightsReserved  page79of233

+CGCONTRDP parameter command syntax
Defined values:
<p_cid> -
a numeric parameter specifies a particular non secondary PDP context
definition. The parameter is local to the TE-MT interface and used in other PDP context-
related commands.
The <p_cid> rage is:
(1 <= <p_id> <= 24) or (100 <= <p_id> <= 179)
<bearer_id> - a numeric parameter identifies the bearer, EPS Bearer in EPS and NSAPI
in UMTS/GPRS.
<APN> - a string parameter which is a logical name that was used to select the GGSN or
the external packet data
network.
<ip_addr> - a string parameter shows the IP Address of the MT. The string is given as
dot-separated numeric (0-255) parameters on the form:
"a1.a2.a3.a4" for IPv4 or "a1.a2.a3.a4.a5.a6.a7.a8" for IPv6.
If the MT has dual stack capabilities the string shows first the dot separated IPv4 Address
followed by the dot
Separated IPv6 Global Prefix Address. The IPv4 address and the IPv6 address parameters
are separated by space:
"a1.a2.a3.a4 a1:a2:a3:a4:a5:a6:a7:a8"
<subnet_mask> - a string parameter shows the subnet mask for the IP Address of the
MT. The string given as dot-separated numeric (0-255) parameters.
If the MT has dual stack capabilities the string shows the dot separated IPV4 subnet mask
followed by the dot
Separates IPV6 subnet mask. The subnet masks are separates by space.
<gw_addr> - a string parameter shows the Gateway Address of the MT. The string is
given as dot-separated
numeric (0-255) parameters.
If the MT has dual stack capabilities the parameter shows first the dot separated IPV4
Gateway address followed
by the dot separated IPV6 Gateway Address. The gateway addresses are separated by
space.
<DNS_prim_addr> - a string parameter which shows the IP Address of the primary
DNS Server. If the MT has
dual stack capabilities the parameter shows first the dot separated IPV4 Address,
followed by the dot separated IPV6 Address of DNS Server.
<DNS_sec_addr> - a string parameter which shows the IP address of the secondary DNS
Server. If the MT has
dual stack capabilities the parameter shows first the dot separated IPV4 Address,
followed by the dot separated IPV6 Address of DNS Server.