ME910G1 HW Design Guide
1VV0301593 Rev.7 Page 89 of 98 2021-02-02
If this module is intended for use in a portable device, you are responsible for separate
approval to satisfy the SAR requirements of FCC Part 2.1093 and IC RSS-102.
Le module a été évalué dans des conditions autonomes mobiles. Pour différentes
conditions de fonctionnement d'un émetteur modulaire autonome dans un hôte
(plusieurs modules émettant simultanément ou d'autres émetteurs dans un hôte), des
tests supplémentaires peuvent être nécessaires (colocalisation, retesting…)
Si ce module est destiné à être utilisé dans un appareil portable, vous êtes responsable
de l'approbation séparée pour satisfaire aux exigences SAR de la FCC Partie 2.1093 et IC
RSS-102.
FCC Additional testing, Part 15 Subpart B disclaimer
The modular transmitter is only FCC authorized for the specific rule parts (i.e., FCC
transmitter rules) listed on the grant, and that the host product manufacturer is
responsible for compliance to any other FCC rules that apply to the host not covered by
the modular transmitter grant of certification. If the grantee markets their product as
being Part 15 Subpart B compliant (when it also contains unintentional-radiator digital
circuity), then the grantee shall provide a notice stating that the final host product still
requires Part 15 Subpart B compliance testing with the modular transmitter installed.
The end product with an embedded module may also need to pass the FCC Part 15
unintentional emission testing requirements and be properly authorized per FCC Part 15.
ANATEL Regulatory Notices
"Este equipamento não tem direito à proteção contra interferência prejudicial e não pode
causar interferência em sistemas devidamente autorizados"
"This equipment is not entitled to protection against harmful interference and must not
cause interference in duly authorized systems"
ME910G1-WW, ME310G1-WW, ML865G1-WW Homologation #: 08566-20-02618