Telit Wireless Solutions SL869-V2 Series - 12. MECHANICAL DRAWING

93 pages

To Next Page

To Previous Page

SL869x-V2 Family Product User Guide

1VV0301175 Rev. 9 Page 67 of 93 2021-07-15

Not Subject to NDA

12. MECHANICAL DRAWING

The SL869x-V2 modules have advanced miniature packaging with a base metal of copper

and an Electroless Nickel Immersion Gold (ENIG) finish.

There are 24 interface pads with castellated edge contacts. The shield is tin-plated.

Figure 26: SL869-V2 Family Mechanical Drawing

Main Page

Default Chapter2
- Applicability Table2
- Table of Contents3
- Contents3
1 Introduction8
- Scope8
- Audience8
- Contact Information, Support8
- Symbol Conventions9
- Related Documents9
2 Product Description10
- Product Overview10
- Product Naming11
- Product Variants11
- SL869-V2S and SL869L-V2S Features12
- ROM Versions12
- SL869-V2 Family Product Features Table13
  - Block Diagrams14
- SL869-V2 Block Diagram14
- SL869L-V2 Block Diagram14
- SL869-V2S Block Diagram15
- SL869L-V2S Block Diagram15
  - Module Photos16
3 Evaluation Kit (Evk)18
- Evaluation Unit19
4 Product Features20
- Multi-Constellation Navigation (SL869-V2 and SL869L-V2 Only)20
- Quasi-Zenith Satellite System (QZSS)20
- Satellite-Based Augmentation System (SBAS)20
- SBAS Corrections21
  - Differential GPS (DGPS) (SL869L-V2 and SL869L-V2S Only)21
  - Assisted GPS (AGPS)21
- Locally Generated AGPS - Embedded Assist System (EASY)21
- Server-Generated AGPS - Extended Prediction Orbit (EPO)22
- Host EPO22
- Full Power Continuous Mode24
- Standby Modes25
- GLP Mode (SL869-V2 and SL869L-V2 Only)25
- Periodic Modes (SL869-V2 and SL869L-V2 Only)26
- Alwayslocate™ Modes28
5 Data Retention29
6 Product Performance30
- Performance - SL869-V2 and SL869L-V230
- Horizontal Position Accuracy - SL869-V2 and SL869L-V230
- Time to First Fix - SL869-V2 and SL869L-V230
- Sensitivity - SL869-V2 and SL869L-V231
  - Performance - SL869-V2S and SL869L-V2S31
- Horizontal Position Accuracy - SL869-V2S and SL869L-V2S31
- Time to First Fix - SL869-V2S and SL869L-V2S31
- Sensitivity - SL869-V2S and SL869L-V2S32
- Jamming Mitigation Performance32
7 Message Interface34
- NMEA Output Messages34
- Standard Messages34
- Proprietary Output Messages35
  - NMEA Input Commands35
- NMEA Commands List36
8 Flash Upgradability37
9 Electrical Interface38
- Pin-Out Diagrams and Tables38
- SL869-V2 Pin-Out Diagram38
- SL869-V2 Pin-Out Table39
- SL869L-V2 Pin-Out Diagram40
- SL869L-V2 Pin-Out Table41
- SL869-V2S Pin-Out Diagram42
- SL869-V2S Pin-Out Table43
- SL869L-V2S Pin-Out Diagram44
- SL869L-V2S Pin-Out Table45
  - DC Power Supply46
- VCC46
- Vbatt46
- Vcc_Rf47
- DC Power Requirements47
- DC Power Consumption: SL869-V247
- DC Power Consumption: SL869L-V248
- DC Power Consumption: SL869-V2S48
- DC Power Consumption: SL869L-V2S49
  - Digital Interface Signals49
- Logic Levels - Inputs49
- Logic Levels - Outputs50
- Antenna Related Signals50
- VCC-RF (Active Antenna Supply Voltage)50
- ANT-ON (SL869L-V2 and SL869L-V2S Only)50
- ANT-OC (SL869L-V2 Only)51
- ANT-SC-N (SL869L-V2 Only)51
- Control (Input) Signals51
- RESET-N (SL869L-V2 and SL869L-V2S Only)51
- Output Signals51
- 1Pps51
  - Serial I/O Ports52
- Serial Port Usage53
- Primary Port Usage53
- Secondary Port Usage53
- UART Port Operation53
- I2C Port Operation (SL869L-V2 Only)53
  - Antenna RF Interface55
- Rf-In55
- Frequency Plan56
- Burnout Protection56
- Jamming Rejection - Active Interference Cancellation56
10 Rf Front End Design57
- RF Signal Requirements57
- GNSS Antenna Polarization58
- Active Versus Passive Antenna59
- GNSS Antenna Gain59
- System Noise Floor60
- RF Trace Losses60
- PCB Stack and Trace Impedance61
- Input to the Pre-Select SAW Filter (SL869-V2 and SL869-V2S Only)61
- Input to the LNA (SL869L-V2 and SL869L-V2S Only)62
- Powering an External LNA (or Active Antenna)62
- RF Interference63
- Shielding64
11 Reference Designs65
12 Mechanical Drawing67
13 Pcb Footprint68
14 Product Packaging and Handling69
- Product Marking and Serialization69
- Product Packaging70
- Moisture Sensitivity72
- ESD Sensitivity73
- Assembly Considerations74
- Washing Considerations74
- Reflow74
- Disposal75
- Safety76
15 Environmental Requirements77
- Operating Environmental Limits77
- Storage Environmental Limits77
16 Compliances78
- EU (RED) Declarations of Conformity79
17 Product and Safety Information83
- Copyrights and Other Notices83
- Copyrights83
- Computer Software Copyrights83
  - Usage and Disclosure Restrictions84
- License Agreements84
- Copyrighted Materials84
- High Risk Materials84
- Trademarks85
- Third Party Rights85
- Waiver of Liability85
  - Safety Recommendations86
18 Glossary87
19 Document History91

Telit Wireless Solutions SL869-V2 Series - 12. MECHANICAL DRAWING

Table of Contents