Telpo TP-8S - Page 66

TP-8/16/24/32/64S User Manual Version No.: V1.2
- 66 -
codec_ep1> fax {parameter}
The parameter is only “t38” or “transparent”, “t38” means the fax protocol is T.38, and “transparent”
means the fax protocol is EAP over radius.
G.723.1 code rate setting command
codec_ep1> g.723.1 {parameter}
The parameter is only “high” or “low”, “high” means the code rate is 6.3Kbps, and “low” means it is
5.3Kbps.
Gain setting command
codec_ep1> gain { parameter 1} { parameter 2}
Therein, parameter 1 is the In-Gain, the value of In-Gain; parameter 2 is Out-Gain, the value of
Out-Gain. The value of the both ranges from -31to 31, unit is dB.
Vibrating buffer depth setting command
codec_ep1> jb {parameter}
The parameter is only “0”, 50”, 100”, 150” or “200”, unit is ms.
“line hook” parameter setting command
codec_ep1> line_hook
This command is set by way of interaction, it does not need any parameter, and the set parameters
include:
 Pulse Min Width
 Pulse Max Width
 Inter Digit Min Time
 Flash Min Time
 Flash Max Time
 Off Hook Time
 On Hook Time
Such as:
codec_ep1> line_hook
Pulse Min Width [40]:
Pulse Max Width [75]:
Inter Digit Min Time [150]:
Flash Min Time [100]:
Flash Max Time [400]:
Off Hook Time [40]:
On Hook Time [400]:
Therein, the value in “[ ]” refers to the value set to the parameter currently, unit is ms.
Output attenuation setting command
codec_ep1> oa {parameter}