The meter will automatically enter sleep mode approx. 30 minutes to save
power consumption.
1. Disable auto power off procedure :
Press
key to turn off the meter.
Press and hold down HOLD key, then press
key to
turn on the meter, the
auto power function will be disabled, and the auto power off symbol “
”
will be disappear.
2. Auto power off mode is enabled each time you turn on the meter and is
automatically disabled as the follow modes.
ENERGY function is active.
Auto datalogging function is active.
PC linked.
VI. MAINTENANCE
6-1 General Maintenance
1. Repairs or services that are not covered in this manual should only be performed
by qualified personnel.
2. Clean the meter and accessories with a damp cloth and a mild soap. Do not use
abrasives, solvent, or alcohol. These may damage the text.
3. Additional to this it is recommended to open the jaws of the Current Clamp and
to wipe the magnetic pole pieces with a lightly oiled cloth. This in order to
avoid rust or corrosion to form on the magnetic poles.
6-2 Battery Replacement
annunciator, replace
new battery is required.
2. Disconnect all test leads and current probe from any power electrical source,
press
key to turn off the meter, and remove the test leads from the jacks.
3. The battery cover is secured to the bottom case by two screws. Using a screw
drive to remove the two screws from the bottom case.
4. Remove battery cover, take out the batteries and replace with new batteries.
(Please note battery polarity)
Shop for Data Logging products online at: www.DataLoggerStore.ca 1.877.766.5412
To Next Page
Loading...
