TESTO 350 Short Manual

3 First steps
17
3.3. Folders / Locations
(only available via Meas. Box tab)
All readings can be saved under the currently active location.
Readings not yet saved are lost when the measuring instrument is
switched off.
Folders and locations can be created, edited, copied and activated.
Folders and locations (incl. protocols) can be deleted.
Calling up the function:
> [
] → Folders → [OK].
Adapting the display:
> Toggle between overview (display of number of locations per
folder) and detailed view (display of all locations per folder):
[Overview] or [Details].
Activating a location:
> Select the location → [OK].
- The location is activated and the menu Measurement Type is
opened.
Creating a new location:
A location is always created in a folder.
1. Select the folder in which the location is to be created.
2. [Options] → New location→ [OK].
3. Enter values or make settings.
The following inputs/settings are possible:
Parameter Description
Location
Enter name
Application
Select application
Fuel
Select fuel
Profile
Enter diameter, length, width, height and area.
For correct measurement of the volume flow you
must set the profile and area. A volumetric flow rate
is calculated from the geometries entered here
together with the measured velocity.

TESTO 350 Specifications

General

Measurement Parameters	O2, CO, NO, NO2, SO2, H2S, CO2, CxHy, H2, Temperature, Draft, Pressure
O2 measurement range	0 to 25 vol. %
CO measurement range	0 to 10, 000 ppm
SO2 measurement range	0 to 5, 000 ppm
Resolution H2	1 ppm
Accuracy O2	±0.2 vol. %
Display	Graphic display
Communication	USB, Bluetooth
Power Supply	Rechargeable battery
Operating Temperature	-5 to 45 °C
Accuracy CO	±5 ppm or ±5% of measured value
Accuracy NO	±5 ppm or ±5% of measured value
Accuracy NO2	±5 ppm or ±5% of measured value
Accuracy SO2	±5 ppm or ±5% of measured value
Accuracy H2S	±5 ppm or ±5% of measured value
Accuracy H2	±5 ppm or ±5% of measured value
Draft measurement range	-99.9 to +99.9 hPa