You can now turn the leadscrew around midway in the leadscrew nut
and slide the X assembly on frame. Slide it down until the leadscrew
goes inside the coupler and then tighten the coupler holding screw.
27 28
Install the motor bracket and coupler with O-ring as shown and
install then it to the Z axis extrusion as shown. The parts are found
from slot B-07 and bag B-07.
Z axis assembly B07
Z axis assembly B07
2 x M3x14 countersunk
2 x T-nut
2 x M4x12 bolt
O-ring
Coupler
To Next Page
Loading...
