Read me first
READ THIS MANUAL COMPLETELY BEFORE ASSEMBLING
AND POWERING UP YOUR PRINTER!
Hazards and Warnings
The TEVO Tarantula Pro 3D printer has motorized and heated parts.
When the printer is in operation always be aware of possible hazards.
Burn Hazard
Never touch the extruder nozzle, or the heater block without first
turning o the hotend and allowing it to completely cool down. The
hotend can take up to twenty minutes to completely cool down. Also,
never touch recently extruded filaments. The filament can stick to
your skin and causes burn.
Fire Hazard
Never place flammable materials or liquids on or near the printer
when powered on or in operation. Liquid acetone and vapors are
extremely flammable.
Pinch Hazard
When the printer is in operation, be careful never to put your fingers
in the moving parts, including the belts, pulleys, gears, wheels or
leadscrews.
Static Charge
Make sure to ground yourself before touching the printer, especially
the electronics. Electrostatic charges can damage electronic compo-
nents. To ground yourself, touch a grounded source.
Age Warning
For user under the ages of 18, adult supervision is recommended.
Beware of choking hazards around children.
Contents
Read me first 01
Contents 02
TEVO support 03
Specification 04
Packing list 05
Assembly of the bottom frame A-01 09
Front panel assembly A-02
11
Y axis parts preparation A-03 12
Bed carriage assembly B-02 13
Finalizing
the
assembly
A-01,
A-02,
A-03
,
B-02 and B-03
14
Controller, PSU and front panel installation 16
Hotbed assembly 18
X axis assembly left side B-03 19
Right side and hotend assembly B-04 21
Upper frame assembly 24
Z axis assembly B07 25
Hotend assembly B-04 and B-05 31
Bed leveling 32
Prepare Slicing Software 33
How to Slice 3D Object for SD Print 40
How to Flash Firmware 42
Troubleshooting 43
Tevo After-Sales 45
01 02
To Next Page
Loading...
