CBLé System Guidebook 33
CH31: Digital Out
Number of Data Elements
This parameter applies only to
CH31
. It sets the number of data elements
that will be in the list. (Default:
1
)
0
1
–22
Clears the channel (refer last note below)
Selects the number of data elements to output
Data Elements
This parameter applies only to
CH31
. It selects the actual digital data
elements to output from the
DIG OUT
channel when the trigger condition
selected in Command 3 is met. The output is a 4-bit (TTL 0–5 Volts)
digital nibble for each data element. For example, 0=0000, 1=0001,
2=0010, 10=1010, 15=1111. (Default:
0
)
0
–15 Selects the values of the data elements to output
Notes:
1. Refer to “Clock-Out Line Operation” (page 68) and “Digital Output
Buffer” (page 69) for additional technical information about this
parameter.
2. Refer to “Digital Nibble” in the Glossary for a definition of this term.
3. The Operation parameter to clear channels for
CH1
,
CH2
,
CH3
,
CH11
,
CH21
and
CH31
does the following:
¦ Turns off the channel indicator for that channel.
¦ Turns off the conversion equation and the
EQ
indicator for that
channel.
¦ Clears data for that channel.
¦ Conversion equation remains loaded, but is not active.
¦ For Channel = 0, the above operations affect all channels.
Additionally, Record Time is turned off.
To Next Page
Loading...
Need help?
General
