Texas Instruments CBL Guide Book

CBLé System Guidebook 37
Data Display Channel
This parameter selects the channel whose data will be displayed. The
rate at which data is displayed during data collection depends on the
sample rate you select in
CMD3
(refer to the Sample Time parameter on
page 39). (Default:
0
lowest active channel.)
Note: This feature works only when the sample time is greater than or
equal to 0.25 seconds.
0
1
2
3
11
21
Displays data of lowest active channel
Displays data of
CH1
Displays data of
CH2
Displays data of
CH3
Displays data of
CH11
(
SONIC
)
Displays data of
CH21
(
DIG IN
)
Note: If you select Data Type 1 (list) or 2 (matrix), everything after this
parameter is ignored. The following parameters only apply when the
Data Type parameter is a 3 (picture).
Pic (Picture) Y Channel
This picture-only parameter lets you select the channel on which to
collect the Y values for picture data. (Default:
1
)
1
2
3
11
21
Collects Y values on
CH1
Collects Y values on
CH2
Collects Y values on
CH3
Collects Y values on
CH11
(
SONIC
)
Collects Y values on
CH21
(
DIG IN
)
Ymin
This picture-only parameter sets the minimum Y value for picture data.
Enter a real number. (Default:
M10
)
Ymax
This picture-only parameter sets the maximum Y value for picture data.
Enter a real number greater than
Ymin
. (Default:
10
)
Note:
Ymin
and
Ymax
, and
Xmin
and
Xmax
(on next page), are
Window
variables on a calculator, except on the TI-85 where they are
Range
variables.

Texas Instruments CBL Specifications

General

Brand	Texas Instruments
Model	CBL
Category	Calculator
Language	English