Texas Instruments CBL

38 CBLé System Guidebook
About CMD2—Data Type and Display Setup
(Continued)
Pic (Picture) X Channel
This picture-only parameter lets you select the channel on which to
collect the X values for picture data. (Default:
0
)
0
1
2
3
L1
Collect X data (X data is a number from 1 to the number of
samples defined in
CMD3
)
Collect X values on
CH1
Collect X values on
CH2
Collect X values on
CH3
Collect X data as the recorded time selected in
CMD3
Note: If Pic X Channel is L1, Record Time must be selected in
CMD3
, or
a blank pic will be returned.
Xmin
This picture-only parameter sets the minimum X value for picture data.
Enter a real number. (Default:
1
)
Xmax
This picture-only parameter sets the maximum X value for picture data.
Enter a real number greater than Xmin. (Default:
512
)
Examples: Data Type Setup Instruction
{2,1}
2= Data Type and Display Setup command.
1= Select list data type using the default to
display lowest active channel data on the CBL.
{2,2,3}
2= Data Type and Display Setup command.
2= Select matrix data type.
3= Display
CH3
data on the CBL. (This assumes
that
CH3
was previously set up.)
{2,3,0,2,L5,
5,0,0,96}
2= Data Type and Display Setup command.
3= Select picture data type.
0= Display channel is lowest channel number set
up.
2= Pic Y channel is
CH2
.
L5= Ymin.
5= Ymax.
0= Pic X channel, collect X data from 1 to the
number of samples.
0= Xmin.
96= Xmax.