Accessing the Setup Programs
Your computer has three setup programs to assist you in
selecting required hardware and software parameters:
❑ Disk-based Setup
❑ ROM-based Setup
❑ Windows-based Setup
Initial Startup Procedure
The first time you boot up your notebook, your system
automatically runs Setup. The following questions are
asked:
1. You are asked which country your keyboard is designed
to support.
Once this information is provided, the Windows Setup
program automatically runs.
2. You are prompted for your name and program serial
number.
3. You are asked which printer you would like as a default
printer.
You exit Windows. System files are automatically
unzipped and the system build begins. When complete,
a video greeting appears. After it runs, the following
options appear:
No Change - keep the video and allow it to run each time
you boot the computer
Remove - removes the video entry from the startup file so
that you keep the video, but it does not run each time
you boot the computer
Accessing the Setup Programs
1-2 Using the Setup Programs
To Next Page
Loading...
Need help?
General
