INS760EN-7 4/91
1.0 Introduction
The Texecom SmartCom creates a new generation of simple connectivity for
customers. With the emergence of cloud technologies Texecom has introduced the
SmartCom to take the Premier Elite product line into the future and enable
customers to transition their systems.
The SmartCom is simple to connect to the Texecom Cloud by generating an App
code.
The SmartCom supports the Texecom Cloud service and the Texecom Connect
app.
Texecom Monitor
Texecom Monitor enables communication to selected ARC's to provide alarm
signalling based on the requirements of EN50131-1, EN50136-2 and EN50131-10.
Care should be taken when installing systems using Texecom Monitor to ensure
the following requirements are met.
Wi-Fi is not permitted1.
Ethernet connections must use screened cable2.
The antenna lead must be less than 3mtrs long3.
CIE congfiguration should be left at factory settings for Grade 2 or Grade 3. 4.
Note:Failure to observe the above will render the SPT non compliant to EN50136-2
and EN50131-10
2.0 System Requirements
To setup a Texecom Connect™ system you will need the following as a bare
minimum:
A Texecom Premier Elite security system with V4 or later firmware installed
To Next Page
Loading...
Need help?
General
