INS760EN-7 7/91
2.2 Network Requirements
Texecom Connect needs to be able to communicate with the outside world so that
push notifications can be sent to the users device; and so that commands from the
device can be sent to the system.
To enable these requirements for WiFi you will need access to the users network
SSID & password, which must have a router or router/modem. Modem only
systems are not supported.
Texecom Connect will only function on networks with DHCP enabled.
Texecom Connect SmartCom operates at 2.4 GHz supporting 802.11b/802.11g &
802.11n wireless technology.
Note: 5GHz networks are not supported.
3.0 Texecom Connect System
The Texecom Connect App is reliant on an existing Texecom security system in
order for it to work. Below is an overview of the full Texecom Connect system, so
you can understand the full ecosystem.
Note: The Texecom connect app is a supplementary feature and not considered
part of the graded ATS
Note: screened Ethernet cable should be used in all installations.
To Next Page
Loading...