INS760EN-7 32/91
Using a laptop or tablet scan for WiFi networks to connect to. Connect to the one
that starts "SmartCOM"
NOTE: It can take up to 60 secs for the SSID to appear on your device. Please be
patient.
Click Connect and enter the passphrase when prompted. The passphrase can be
found on the label inside the SmartCom.
Once connected, open a web browser and in the address bar enter 192.168.2.1,
then press return or refresh.
A list of available WiFi networks should appear in the browser.
Click the button next to the required connection and enter the WiFi passphrase.
Click "Connect".
The SmartCom will flash the WiFi LED quickly while it connects to the WiFi network.
Once the connection is made, the WiFi LED will remain on permanently.
The SmartCom is now connected to the WiFi and ready for use.
When connected via WiFi the IP address will be displayed by the panel as 0.0.0.0
this is normal and should not be changed.
6.3 Router Setup & Ports
Router Setup & Ports
The SmartCom communicator has been designed to work with minimal setup or
help from IT professionals, however on high security or managed networks
typically seen in larger commercial properties, it may be necessary to open some
outbound ports to ensure the SmartCom operates correctly. Remember the
SmartCom does not require any inbound ports to be opened on the network, this
ensures the network remains as secure as possible. We recommend following the
below steps for correct operation of your SmartCom communicator.
Where you suspect a network may be restricted, we suggest sending the below
To Next Page
Loading...
Need help?
General
