INS760EN-7 80/91
At this point if the system already has Ricochet enabled devices learned and
a panel profile that is saved in Wintex, you can press n/n and proceed to
update the panel profile as detailed later.
If you have any additional Ricochet enabled devices to be learned, and no
saved panel profile follow the detail below.
The Texecom Connect SmartPlug MUST be added to the system using the
app once all other steps are complete.
Learn all of your devices (Not SmartPlugs!) And then place them in their final
location and allow to commission for 15 minutes. Once learning is complete press
To Next Page
Loading...