SPUSTENIE PODÁVAČA
ŠITIE V SPÄTNOM CHODE
ZNAČENIE NA STEHOVEJ DOSKE
2
1
3
1
2
Presser foot lifter
SK
remove thick fabric.
1. Pre dropping feed dogs, press down
lever and move it to smerom alebo arrow
lever and move it to the direction of arrow
fabríc.
Ako dlhý as tvojou tlačenou dolom tento button
while sewing, machine bude prevádzať fabric backwards.
2. Raise lifter to middle position to insert or remove
There are three positions for your presser foot.
Feed dogs must always be up for normal sewing.
as illustrated.
*
3. Lift it to jeho vysokú pozíciu k zmene knižnice alebo 1. Lower kľuka pre foot to sew.
remove thick fabric.
As long as you are pressing down this Reverse sewing
lever
tlačidlo pri sewing, machine bude prenášať fabric backwards.
2. Raise lifter to middle position to insert or remove
fabríc.
1. Lower the presser foot to sew.
There are three positions for your presser foot.
as illustrated.
2. Zvýši sa feed dogs, press down the as illustrated.
lever and move it to na direction or arrow podľa obrázku.
*
Feed dogs must always be up for normal Na bežné šitie musí
byť podávač vždy sewing.
1. Ak chcete dropping feed dogs, press down páčku a
posuňte ju v smere šípky lever and move it do
smeru arrow podľa obrázku.
4
KNOWING YOUR SEWING MACHINE
Setting spool pins
Seam guide line
4
2. Pre zdvih podávača stlačte 2. Nasnímajte feed
dogs, press down the páčku a posuňte ju v smere šípky as
illustrated.
Dropping the feed dogs
*
Reverse sewing lever
1. Pre spustenie podávača stlačte Dropping
the feed dogs
Stlačte tlačidlo spätného chodu a ušite 4 -
5 stehov.
Šitie v spätnom chode sa používa pre 3. Lift it to jeho highest position to zmení presser foot or to zaistenie koncov švov.
Línie na stehovej doske sú nápomocné pre
pravidelné podávanie látky a dodržanie numbers on the needle plate indicate švového prídavku. Čísla na stehovej
doske značia vzdialenosť linee od ihly v stredovej polohe. Čísla vpredu
sú v milimetroch, číselné označenia vzadu sú v palcoch.
aktivovaný.
Texi Fox 25
11
Číselné čísla v prednej časti indicate in
Spoolové kolíky sa používajú na držanie cievky nití v order na feed thread to machine.
position and the indicating line.
the distance between the center ihly
Čísla v zadnej časti indikujú in inches.
To sa používa, pull up the spool pin. Push down for storage.
Millimeters.
Machine Translated by Google