PIXIUM STATIC X-Ray Flat Panel Detectors - End User Manual
Document reference : 63137046 -
January 2024
Page 17
OPEN
This document may not be reproduced, modified, adapted, published, translated, in any way, in whole or in part, or disclosed to a third party without the prior written consent of THALES.
© 2017-2023 THALES All rights reserved
83270259-SER-MIS-EN-002
6. SAFETY AND PRECAUTIONS
6.1. General Precautions
6.1.1. PIXIUM PORTABLE all series
In case of earthquake, the Product must be inspected before being reused.
Power supply inversion or out of range may harm the detector. Be sure to correctly connect and
clamp the power supply cable.
The detector is sensitive to moisture. While not used, it must be stored with protection against
humidity.
If this condition is not observed, the detector may be damaged or destroyed.
Only qualified and authorized service engineers must carry out product installation, adjustment
and maintenance described in this document.Qualified in this context means that the engineers
have been trained accordingly or have acquired the necessary experience in practice.Authorized
means that the engineers have been authorized by the operator of the system to perform
maintenance work.
Usage of the PIXIUM detectors is strictly reserved to qualified staff.
In case of collision of the detector with a tough surface or in case of rough shock, a visual
inspection is required to detect any mechanical deformation. In such case, the use of detector
must be considered as hazardous and the detector must be returned to Thales for analysis and /
or repair.
Power supply inversion or out of range may harm the detector. Be sure to correctly connect and
clamp the power supply cable.
Avoid to place the detector too close to life supporting devices.
To Next Page
Loading...