PIXIUM STATIC X-Ray Flat Panel Detectors - End User Manual
Document reference : 63137046 -
January 2024
Page 25
OPEN
This document may not be reproduced, modified, adapted, published, translated, in any way, in whole or in part, or disclosed to a third party without the prior written consent of THALES.
© 2017-2023 THALES All rights reserved
83270259-SER-MIS-EN-002
• Use only the BATTERY EZ HD in the application for which it was intended.
• When possible, remove the BATTERY EZ HD from the equipment when not in use.
• Retain the original product literature for future reference.
• After extended periods of storage, it may be necessary to charge and discharge the
BATTERY EZ HD several times to obtain maximum performance.
• Keep the BATTERY EZ HD out of the reach of children.
• Always purchase the correct battery for the equipment.
• Before use, visually check the BATTERY EZ HD for any physical damage. If damage is
found, the BATTERY EZ HD must not be used.
• Keep the BATTERY EZ HD lean and dry.
• Wipe the BATTERY EZ HD terminals with a clean dry cloth if they become dirty.
• The BATTERY EZ HD needs to be charged before use. Always use the dedicated battery
charger and refer to the manufacturer’s instructions or equipment manual for proper charging
instructions.
• Do not dismantle, open or shared the BATTERY EZ HD.
• Do not remove the BATTERY EZ HD from its original packaging until required for use.
• Do not subject the BATTERY EZ HD to mechanical shock.
• Do not use any charger other than that specifically provided for use with the equipment.
• Do not use any cell or battery which is not designed for use with the equipment.
• Do not leave the BATTERY EZ HD on prolonged charge when not in use.
• Dispose of properly.
• Refer to BATTERY EZ HD safety instructions before use.
• Before use, visibly check the CHARGER EZ HD and BATTERY EZ HD for any physical
damage. If damage is found, the CHARGER EZ HD and BATTERY EZ HD must not be used.
• Keep the CHARGER EZ HD out of the reach of an operator with an altered condition, phys-
ical or mental.
• Prevent metallic objects from coming into contact with the metal part of the DC plug of the
CHARGER EZ HD. If it happens, a short circuit may occur and the unit may be damaged.
• The CHARGER EZ HD is an ordinary accessory, not intended for use in the patient envi-
ronment.
• Place the CHARGER EZ HD indoors on a hard flat heat resistant surface, in a well-venti-
lated area.
• Remove BATTERY EZ HD when the charger is not in use.
• Safeguard from moisture, respect operation and storage temperature limits.
• Dry the CHARGER EZ HD and store protected from impacts and humidity.
• Always keep metallic contacts clean.
• Keep the CHARGER EZ HD out of the reach of children.
• Keep the CHARGER EZ HD clean and dry.
• Retain the original product literature for future reference.
• When possible, remove the BATTERY EZ HD from the equipment when not in use.
To Next Page
Loading...