EasyManuals Logo

Thecus N5200B, N5200BR User Manual

Thecus N5200B, N5200BR
90 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
RAID Current RAID status.
System Fan Current system fan status.
CPU Fan Current CPU fan status
2006/06/16 12:00 Current system time.
The N5200 will rotate these messages every one-two seconds on the LCD display.
USB Copy
The USB Copy function enables you to copy files stored on USB devices such as
USB disks and digital cameras to the N5200 with a press of a button. To use USB
copy, follow the steps below:
1. Plug your USB device into an available USB port on the Front Panel.
2. In Display Mode, press the Down Button ().
3. The LCD will display “USB Copy?
4. Press Enter (
) and the N5200 will start copying USB disks connected to
the front USB port.
5. All of data will be copied into system folder named “USBcopy”.
Management Mode
During setup and configuration, the LCD will be in Management Mode.
To enter into Management Mode, press Enter (
) and an “Enter Password
prompt will show on the LCD.
At this time, the administrator has to enter the correct LCD password. System will
check whether the correct LCD password has been entered. The default LCD
password is “0000”. If correct password is entered, you will enter into the
Management Mode menu.
Management Mode
Item Description
WAN Setting IP address and netmask of your WAN ports.
LAN Setting IP address and netmask of your LAN ports.
Link Agg. Setting Select Load Balance or Failover. (N5200B only)
Change Admin Passwd Change administrator’s password for LCD operation.
Reset to Default Reset system to factory defaults.
Exit Exit Management Mode and return to Display Mode.
NOTE
You can also change your LCD password using the Web Administration
Interface by navigating to System > Administrator Password. For
more on the Web Administration Interface, see Chapter 4: System
Management.
Typical Setup Procedure
From the Web Administration Interface, you can begin to setup your N5200 for
use on your network. Setting up the N5200 typically follows the five steps
outlined below.
For more on how to use the Web Administration Interface, see Chapter 4:
System Management > Web Administration Interface.
19

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thecus N5200B, N5200BR and is the answer not in the manual?

Thecus N5200B, N5200BR Specifications

General IconGeneral
BrandThecus
ModelN5200B, N5200BR
CategoryServer
LanguageEnglish

Related product manuals