EasyManuals Logo

Thermal Dynamics CUTMASTER 151 Service Manual

Thermal Dynamics CUTMASTER 151
96 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
APPENDIX A-24 Manual 0-4669
APPENDIX 16: Publication History
Date Rev. Comments
3/25/05 - - Placed on-line, no official ‘release’ done.
6/6/05 - - Revised – added 400V, 460V, CE units, updated 208/230V replacement rear panel &
cord cat no., added 600V IGBT.
6/27/05 - - Corrected Input Wiring Specs.
7/8/05 - - Added 230V CSA rear panel and power cords parts per ECO 101731.
10/12/05 - - Changed input wiring chart to show Non CSA and CSA with some new cable ratings.
2/3/06 - - Updated all art showing IGBT wiring by changing the bottom pair of red and black
wires to show the black attached to the upper connection point.
4/28/06 AA Updated schematics per ECO B016. Updated torque specs on replacement parts per
ECO 101948. Added publication history. Started using new cover styles.
1/5/07 AB.01 Updated parts list and 400V schematic with RoHS information per ECOB270
3/14/07 AC.01 Updated 600 volt schematic to show new fuse.
4/13/07 AD.01 Updated C & Cr section, revised Troubleshooting Section, pg. 4-13: D: deleted
text 1a. & 2a. references to Subsections 4.10-C & 4.10-F, updated Inside and
Rear cover.

Table of Contents

Other manuals for Thermal Dynamics CUTMASTER 151

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Thermal Dynamics CUTMASTER 151 and is the answer not in the manual?

Thermal Dynamics CUTMASTER 151 Specifications

General IconGeneral
BrandThermal Dynamics
ModelCUTMASTER 151
CategoryWelding System
LanguageEnglish

Related product manuals