Thermal Dynamics CUTMASTER A120 User Manual

CUTMASTER A120
Manual 0-4989 2-1 INTRODUCTION
SECTION 2 SYSTEM:
INTRODUCTION
2.01 How To Use This Manual
This Owner’s Manual applies to just specication
or part numbers listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay
particular attention to the information provided
under these headings. These special annotations
are easily recognized as
follows:
NOTE
An operation, procedure, or background infor-
mation which requires additional emphasis or is
helpful in efficient operation of the system.
CAUTION
A procedure which, if not properly followed, may
cause damage to the equipment.
!
WARNING
A procedure which, if not properly followed, may
cause injury to the operator or others in the op-
erating area.
WARNING
Gives information regarding possible electrical
shock injury. Warnings will be enclosed in a box
such as this.
Additional copies of this manual may be
purchased by contacting Victor Technologies
at the address and phone number in your area
listed on the back cover of this manual. Include
the Owner’s Manual number and equipment
identication numbers.
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF format
by going to the
Thermal Dynamics web site listed below and
clicking on Thermal Dynamics and then on the
Literature link:
http://www.thermal-dynamics.com
2.02 Equipment Identification
The unit’s identication number (specication
or part number), model, and serial number
usually appear on a data tag attached to the
rear panel. Equipment which does not have a
data tag such as torch and cable assemblies are
identied only by the specication or part number
printed on loosely attached card or the shipping
container. Record these numbers on the bottom of
page i for future reference.
2.03 Receipt Of Equipment
When you receive the equipment, check it against
the invoice to make sure it is complete and inspect
the equipment for possible damage due to ship-
ping. If there is any damage, notify the carrier
immediately to le a claim. Furnish complete
information concerning damage claims or ship-
ping errors to the location in your area listed in
the inside back cover of this manual.
Include all equipment identication numbers as
described above along with a full description of
the parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging
the equipment when using bars, hammers, etc., to
un-crate the unit.

Thermal Dynamics CUTMASTER A120 Specifications

General

Brand	Thermal Dynamics
Model	CUTMASTER A120
Category	Welding System
Language	English