Thermo Scientific DensityPRO+ - Page 104

Index
J
jumper settings
for detector type selection, 4-7
for duty cycle mode, 4-12
L
licensing, 3-2
M
mounting
dual chain configuration, 3-9–3-12
gauge head, 3-7–3-14
pipe saddle configuration, 3-12
pipe spool configuration, 3-14
N
National Electric Code (NEC), 4-1, 4-2
NEC. See National Electric Code., See National Electric Code.
O
ordering information
1400A transmitter, A-1
1400S transmitter, A-2
ion chamber detector, A-1
scintillation detector, A-1
P
power
options, 3-3
supply wiring
ion chamber detector, 4-9
scintillation detector, 4-7–4-8
transmitter, 4-10
R
receiving the instrument, 2-2
relay, 4-12
relay contacts, 4-6
RS232 serial port, 4-6, 4-13
RS485 serial port option, 4-6, 4-13
S
safety, ix–x, 2-2, 3-2, 3-4, 3-7, 4-1
scintillation detector. See detector.
serial communications, 4-13–4-14
shipping the instrument, 2-2
source, 3-1
installation, 3-7–3-14
guidelines, 3-2–3-3
source head. See source.
source housing. See source.
specifications, B-1–B-4
storing the instrument, 2-2
T
temperature compensation, 4-13
transmitter, 3-1
1400A ordering information, A-1
1400A specifications, B-3
1400S
EMC requirement for ATEX units, 4-5, D-1–D-2
1400S ordering information, A-2
1400S specifications, B-4
AC power supply installation, 3-6
general wiring procedure, 4-6–4-7
installation, 3-5–3-6
guidelines, 3-2–3-3
operating temperature range, 3-2
PCB installation, 3-5
power options, 3-3
power supply wiring, 4-10
W
wiring
detector signals, 4-11–4-12
EMC requirement for ATEX 1400S transmitter, 4-5, D-1–
D-2
general procedure
ion chamber detectors, 4-4–4-5
scintillation detectors, 4-2–4-3
transmitters, 4-6–4-7
in hazardous areas, 4-1
INDEX-2 DensityPRO+ Installation Guide Thermo Fisher Scientific