Installation
The Transmitter
The Transmitter
Warning Do not install the unit in any hazardous area other than those
approved. Refer to the equipment tag for the specific approvals applicable
to the configuration of your instrument. Follow all instructions on the
installation drawings. ▲
Warning Do not apply power to the unit in any hazardous area unless the
safety ground is properly wired inside the unit and the cover is properly
installed. ▲
Warning Use proper lifting procedures during installation to avoid
injury. ▲
Refer to the proper dimensional drawing for the transmitter mounting
dimensions:
● 868212: 1400A transmitter with non-metallic enclosure (NEMA
4X)
● 868214: 1400A transmitter with cast aluminum enclosure (NEMA
7/ NEMA 4)
● 208-140002: 1400S transmitter with stainless steel enclosure
(NEMA 4X/IP65)
Mount the transmitter in one of the following two ways:
● With four screws: Place one screw through each of the four holes in
the transmitter enclosure’s flange and tighten.
● With four nuts, four bolts, and eight washers: Place one bolt
through each of the four holes in the transmitter enclosure’s flange,
with one washer on each side. Screw on the nuts, and tighten the
bolts.
3-4 DensityPRO+ Installation Guide Thermo Fisher Scientific
To Next Page
Loading...
