Thermo Scientific DensityPRO+ - Index

Index
1
1400A. See transmitter.
1400S. See transmitter.
C
Canadian Nuclear Safety Commission (CNSC), 2-2, 3-2
Canadian Standards Association (CSA), 4-10
CNSC. See Canadian Nuclear Safety Commission.
commissioning, 3-2
communications
HART, 4-15
wiring
optional RS485, 4-14
RS232, 4-14
contact closure inputs, 4-6, 4-13, B-3, B-4
contact information, 5-1
CSA. See Canadian Standards Association.
current outputs, 4-6, 4-12, B-3, B-4
D
Department of Transportation (DOT), 2-2
detector, 3-1
general wiring procedure
ion chamber detectors, 4-4–4-5
scintillation detectors, 4-2–4-3
installation, 3-7–3-14
guidelines, 3-2–3-3
ion chamber
ordering information, A-1
specifications, B-1
jumper setting for detector type selection, 4-7
operating temperature range, 3-2
power options, 3-3
power supply wiring
ion chamber detector, 4-9
scintillation detector, 4-7–4-8
scintillation
ordering information, A-1
specifications, B-2
signal wiring, 4-11–4-12
DOT. See Department of Transportion.
E
electrostatic discharge (ESD), 2-1–2-2
EMC requirement for ATEX 1400S transmitter, 4-5, D-1–D-2
ESD. See electrostatic discharge.
F
ferrite clamps
EMC requirement for ATEX 1400S transmitter, 4-5, D-1–
D-2
flow input, 4-13
G
gauge head, 3-1, Also see detector., Also see source.
mounting, 3-7
H
handling the instrument, 2-1–2-2
HART communications, 4-15
I
installation
drawings, C-1–C-45
gauge head, 3-7–3-14
guidelines, 3-2–3-3
in hazardous areas, 3-2, 3-4, 4-2
transmitter, 3-5–3-6
installing
drawings for, C-1–C-45
guidelines for, 3-2–3-3
in hazardous areas, 3-2, 3-4, 4-2
the gauge head, 3-7–3-14
the transmitter, 3-5–3-6
ion chamber detector. See detector.
Thermo Fisher Scientific DensityPRO+ Installation Guide INDEX-1