Installation
The Gauge Head
3-14 DensityPRO+ Installation Guide Thermo Fisher Scientific
Pipe Spool Mount ipe Spool Mount
A pipe spool is normally a 30-inch section of pipe with either mounting
plates or a complete gauge head already installed. Often, a length of the
required pipe is sent to Thermo Fisher to be converted into a pipe spool
mount.
Caution Use correct pipe fitting techniques suitable for the pipe being used
and the process material that the pipe will handle. ▲
1. Assemble the pipe spool into the existing pipe.
2. Position the source housing so its identification tag is upright.
3. If the detector and source housings are not already installed, bolt them
to the mounting plates on either side of the pipe saddle.
4. Tighten all bolts securely.
To Next Page
Loading...
