THOMSON SpeedTouch 510 - Speedtouch USB Connection Setup for Microsoft Windows Operating Systems

1 SpeedTouch™ Installation
E-SIT-CTC-20030306-0003 v3.0
13
1.2.2 SpeedTouch™ USB Connection Setup for
Microsoft Windows Operating Systems
Supported Operating
Systems
Installing and using the SpeedTouch™ USB connection is supported for following Micro-
soft Windows Operating Systems:
• Windows 98/98SE or Windows ME
• Windows 2000 or Windows XP
You may need the Windows installation CD-ROM during installation.
Minimum system
requirements
• For Windows 98/98SE/ME:
• Pentium processor 166 MHz or compatible
• 32 megabytes (MB) of memory
• For Windows 2000/XP:
• Pentium II processor or compatible
• 64 MB of memory
• 30 MB of free disk space
Prerequisites Make sure to remove any previous SpeedTouch™USB or SpeedTouch™330 installation
that may reside on your PC before you install the USB drivers from the Speed-
Touch™Setup CD-ROM.
Installing the
SpeedTouch™ USB
connection
The installation is Plug and Play, meaning that installation will require almost no effort.
Make sure both your PC and SpeedTouch™ are turned on and operational.
Proceed as follows
1 Insert the USB cable provided into the SpeedTouch™ USB port marked with the
USB logo: .
2 The other end of the USB cable fits in (one of) the USB port(s) of your PC. In
most cases your PC's USB port is marked with the same USB symbol.
Note You can also connect your computer to the SpeedTouch™ via a USB
hub.
3 Windows will automatically recognize the SpeedTouch™:
4 The Windows Found New Hardware Wizard appears:
This wizard will guide you through the installation procedure of the Speed-
Touch™USB drivers.
Click Next to continue.