1 SpeedTouch™ Installation
E-SIT-CTC-20030306-0003 v3.0
26
1.3.2 Configuration Setup for other Operating
Systems
Supported Systems As the SpeedTouch™ is OS-independent, this configuration setup can be used by any
computer system.
Note The following procedure may equally be used on MS Windows OSs.
TCP/IP Ensure that your operating system has a valid TCP/IP configuration.
Configure your computer with a static Net10 private IP address, e.g. 10.0.0.1. Ensure,
however, that you do NOT use the 10.0.0.138 IP address as this is the default IP address
of the SpeedTouch™.
To ensure that IP connectivity exists, you can ping the SpeedTouch™.
Procedure The configuration setup proceeds as follows:
1 To ensure that the SpeedTouch™ is in its factory default state, reset the Speed-
Touch™ to the default configuration. See “5 Troubleshooting” on page 69.
2 Open a web browser and browse to the SpeedTouch™'s default IP address
10.0.0.138. See “3 SpeedTouch™ Web Interface” on page 43 for more informa-
tion.
3 As a result the SpeedTouch™ System Info web page appears.
Expand the Advanced Topics and click Easy Setup.
Note If the SpeedTouch™ is in factory defaults, the Easy Setup wizard will appear
automatically.
4 The Welcome to the SpeedTouch™ Setup Wizard window appears:
Click Next to continue.
To Next Page
Loading...
