1 SpeedTouch™ Installation
E-DOC-CTC-20030814-0001 v1.0
18
Additional configuration Some additional configuration may be needed:
• Wireless Settings
When running the SpeedTouch™ Setup wizard, the SpeedTouch™ wireless
Access Point settings will be set to their default values. You might need to re-asso-
ciate your WLAN clients, using the factory defaults WLAN settings as specified in
“4.1 First-time Wireless Client Association” on page 43.
For additional security of your wireless network it is recommend to “personalize”
your SpeedTouch™ wireless Access Point settings. See “4 Wireless Connectivity”
on page 41 for more information.
• MS Windows IP configuration
Most Service profiles will enable the SpeedTouch™ DHCP server. Since by default
a PC’s Ethernet interface is configured for obtaining its IP configuration dynami-
cally (DHCP client), in most cases, no additional configuration is required.
To make sure that all PCs are configured as expected (DHCP or fixed IP
addresses):
1 Re-run the SpeedTouch™ Setup wizard on every PC.
2 Select Change the LAN configuration.
3 Follow the instructions.
Note For fixed IP configurations, or other advanced settings, please follow
the instructions provided by your Service Provider or network admin-
istrator.
• It is recommended to install Dr SpeedTouch™ to allow monitoring and trouble-
shooting of your SpeedTouch™. Proceed with “3 Dr SpeedTouch™” on page 37.
To Next Page
Loading...
