THOMSON SpeedTouch 545 - Upgrade Via the Speedtouch Upgrade Wizard

7 Support
E-DOC-CTC-20030814-0001 v1.0
81
7.3.3 Upgrade via the SpeedTouch™ Upgrade
Wizard
Introduction The procedure described in this section are valid only in case:
• You run an MS Windows Operating System.
• Your SpeedTouch™ and computer are connected through a wired network.
• The new system software file is of the type adnta-a_AA42xx.bin,
e.g. adnta-a_AA4215.bin.
During the upgrade procedure all configuration settings are backed up by the wizard
and restored after uploading the system software. Therefore, you do not need to back
up the SpeedTouch™ configuration yourself.
Upgrade procedure Proceed as follows:
1 Insert the SpeedTouch™ Setup CD-ROM in your computer’s CD-ROM drive. The
SpeedTouch™ CD Browser will start automatically.
Note If the SpeedTouch™ CD Browser window does not appear automati-
cally, click Run on the Start menu and enter the following path:
D:\Menu.exe where D stands for the drive letter of your CD-ROM
drive.
2 The choose language window prompts you to select a language:
Select your language and click OK.
3 The SpeedTouch™ CD Browser menu appears:
Click Diagnostics & Maintenance.