5 SpeedTouch™ Web Interface
E-DOC-CTC-20030814-0001 v1.0
47
5 SpeedTouch™ Web Interface
Introduction The SpeedTouch™ comes with integrated local configuration capabilities.
The local configuration, via the SpeedTouch™ web interface, is based on the HTTP
server/web browser concept.
It allows you to configure your SpeedTouch™ via a web browser using HTML pages
from any local computer attached to the SpeedTouch™ (Wireless) LAN.
Preconditions Before accessing the SpeedTouch™ web pages, make sure that either:
• Your Web browser is not using a proxy server.
• The SpeedTouch™ IP address is not submitted to a proxy server.
For more information on how to disable your web browser's proxying, please consult
the web browser's user's guide.
Use of the
SpeedTouch™ web
interface
In most cases, the SpeedTouch™ is correctly configured for your Internet connectivity
via the Service you selected during SpeedTouch™ Configuration Setup, implying that no
further configuration on the web interface is needed.
Access to the
SpeedTouch™ web
interface
To access the SpeedTouch™ web pages:
1 Start the web browser on your computer.
2 Browse to the SpeedTouch™ at the SpeedTouch™’s IP address (in most cases
10.0.0.138).
3 If a system password has been set, an authentication window will be displayed. You
must enter the user name and system password before access will be granted.
Access to the
SpeedTouch™ web
interface via UPnP™
If your computer is UPnP™ enabled you can access the pages as follows:
1 Click (Settings >) Control Panel on the Start menu to open the Control Panel.
2 Go to Network and Internet Connections > My Network Places.
Note If you use the Control Panel in Classic View, click Network Connections
in the Control Panel and Network Places under Other Places.
3 The following window appears:
Double-click the SpeedTouch™ icon.
4 If a system password has been set, an authentication window will be displayed.
Enter user name and system password in the appropriate fields and click OK.
To Next Page
Loading...
