English
9
Choose a channel with the p/q buttons. Alternatively, you can digit the channel number with the
0~9 buttons on the remote control or press OK in viewing mode to display the channel list. The
volume can be adjusted with the tu buttons.
6.0 OPERATION
6.1 Changing channels
Following ways are possible for changing channels with your new receiver:
- Via direct access using the 0~9 buttons.
- Via the channel list using OK and the PG+/PG- buttons.
- Via the p/q buttons.
6.1.1 Direct access via 0~9 buttons
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less than four
digits is possible. Just wait a few seconds and your receiver will switch to the selected channel or press
OK immediately after selecting the channel number.
6.1.2 Channel list
Press OK in viewing mode to display the Channel List. Use p/q in the channel list to highlight your
channel of choice and press OK once to select the highlighted channel. Press OK again to leave the
channel list mode. Inside the channel list it is possible to use the PG+/PG- buttons as well in order to
scroll page-wise through the list.
TIP Use tu to toggle between the All Channel list and favourite list(s) or
press FAV in viewing mode for a list of the available favourite lists.
6.1.3 Using the p/q buttons
p switches to the next channel.
q switches to the previous channel.
6.2 Info Banner
While watching TV you can press the INFO button at any time to access current information about
the channel and event*. Press INFO twice for technical details about the current channel.
*Event information is displayed when available. Availability depends on the broadcast.
6.3 Selection of audio language
Some channels support a choice of audio formats and/or languages. To select another audio stream,
press AUDIO in viewing mode. A list with available audio streams will now be displayed. Use p/q
to select a stream and conrm with OK. The audio channel as stereo, mono, left and right can be
selected with the tu buttons.
6.4 Teletext
Your receiver includes a fully featured Teletext. To access Teletext, press the TEXT button in viewing
mode and use the 0~9 buttons to input the number of the page you wish to see. The coloured
buttons of the remote control allow you to jump to selected pages directly, as indicated on the
bottom of the Teletext screen. Use the p/q buttons to select one page up or down, use the tu
buttons to select subpages. Press or TEXT to get back to viewing mode.
6.5 Subtitles
Some channels support a choice of subtitle languages. Press SUB in viewing mode to display a list of
available subtitle languages. Select your subtitle of choice with p/q and press OK to conrm. Press
to leave without making changes.*
*Availability of DVB/HoH subtitles depends on the broadcast. If subtitles are not supported, they can be activated via Teletext if available.
To Next Page
Loading...
