THOMSON THC301 - Tools

English
15
Use p/q to select Parental Lock from the System Setup menu and press OK to proceed. You will be
asked to enter your PIN code. (DEFAULT PIN: 1234)
Menu Lock: Locks the installation menu. You can set Menu Lock to On or O.
Parental Rating: Choose between: O, 10 years and up to 18 years. Channels with a
parental rating above the chosen age will be protected with a PIN code (if
rating is available in your local broadcast).
New Password: Enter your new PIN code (4 digits) here.
Conrm Password: Re-enter your PIN code here to conrm.
7.3.6 OSD Setting
This menu allows you to change settings for: OSD Timeout and OSD Transparency.
OSD Timeout: Sets the duration time of on screen banners and messages remove. The
range is 1~10 seconds or Always On.
OSD Transparency: To set the OSD transparency from O ~ 40% with 10% steps.
7.3.7 Audio Description
Audio Description is a service by the broadcaster in which the content on screen is being described
for the visually impaired. Select AD Service On and Use AD as default also On to activate the service.
With AD Volume Oset the level of the AD text can be adjusted.
NOTE Availability of Audio Description depends on the broadcast.
7.3.8 Auto Standby
Auto Standby is a new feature that helps you reducing power consumption. When set to 3, 4 or 5
hours, the receiver will switch to standby if it doesn’t receive any commands during this time. Set Auto
Standby to O to deactivate the automatic standby function.
Default is 3 hours.
7.4 Tools
Press MENU in viewing mode to enter the Main Menu.
Select the Tools submenu with p/q and press OK or u to enter.
Use p/q to highlight the submenu of choice and press OK proceed.
Press  to leave.
7.4.1 Information
This submenu shows receiver specic information such as hardware version and software version.
Please have the Information screen on hand when you call our hotline. The person who answers your
call might ask for the information given in this screen.
7.4.2 Load Factory Settings
This option allows you to reset the receiver to factory settings, which clear all stored channels.
Warning! By resetting your receiver to factory default, all your settings and stored
channels will be permanently deleted. Please use this option with care.
Use p/q to select Load Factory Settings in the Tools menu and press OK. You are asked to input
your PIN code.
Input the correct PIN code using the 0~9 (DEFAULT PIN: 1234). A conrmation window is displayed.
Select Yes to return to factory settings.
The receiver will return to its initial state and show the Welcome page.
Select No to cancel.
Press  to leave.