THOMSON THC301 - 2 Your Receiver; Default Pin: 1234; Front Panel; Rear Panel

English
5
- It is advised not to store important information on USB storage devices used with the receiver.
Always make backups of data on your USB storage device before using it with this receiver. We will
not take responsibility for any loss of information or circumstances caused by loss of information.
*This user manual describes the full functionality including the recording function and may not be applicable if the software for
recording via USB has not yet been installed.
2.0 YOUR RECEIVER
2.1 DEFAULT PIN: 1234
2.2 Front Panel
Fig. 1
1. IR Sensor Receives commands from the remote control
2. LED Display Shows channel number and time in standby
3. Mode Indicator LED RED indicates that the receiver is in STANDBY mode.
4. Standby/ON button Switches the receiver ON or into Standby
5. USB To connect your USB storage device.
2.3 Rear Panel
Fig. 2
1. CABLE IN Connect your receiver to the wall connector provided by the cable
operator
2. CABLE OUT Connect your receiver to another digital receiver or to a TV to keep
using its internal (analogue) tuner (loop through function)
3. HDMI Connect your receiver with your TV set using an HDMI cable.
4. TV SCART Connect your receiver with your TV set using a SCART cable.
5. S/PDIF (coax.) Connect your receiver to a digital home theatre, AV receiver or
digital audio amplier.
6. Power connector The receiver requires a wall adapter, mains voltage input 100~240
V AC 50~60Hz 12 V, 0.5 A DC output. Please check the local power
conditions before connecting the receiver to the mains supply.
2.4 Remote Control
Fig. 3
1. q Switches the receiver On/Standby.
2. ! Mutes all audio outputs of the receiver
3. 0~9 Enter channel number in TV mode or value input in menu
4. TV/R Toggles between TV or RADIO mode.
5.  No function
6. FAV Opens the favourite group selection.
7. 9 One step back in menu or back to previous channel.
8. AUDIO Opens the audio language selection*
9. INFO Opens the current channel information; 2x opens the technical
information about the current channel.
10. EPG Opens the EPG (Electronic Programme Guide) in TV mode*
11. p/q Change channel to next/previous. Menu: Moves the cursor up/
down.
12. tu Decreases/increases the volume level. Menu: Change settings for
specic menus.
13. OK Opens the current channel list in menu: for conrmation
14. MENU Opens the main menu, in a menu you will get one step back.
15.  Exits from the menu or sub-menu.
16. VOL+/VOL- Increases/decreases the volume level.
17. P+/P- Page up/down in all list modes.
18. LIST Call the current channel list.