12
with OK. When you have nished editing, press YELLOW to enter the changes. When all changes
have been made, press twice. Select Yes to save the changes or No to discard.
Delete
Press BLUE in Edit Channel to enable the Delete function. The Delete sign will move up to indicate
that Delete is selected. Use p/q to highlight a channel and press OK to mark it for deletion. When
you have marked all channels you wish to delete, press twice. A conrmation banner will be
displayed. Select Yes to delete the marked channels or No to cancel.
7.1.2 Radio Channel List
Basically, the operation of the Radio Channel List is the same as in the TV Channel List. The only
difference is that in Radio Channel List there is no video information, so it will always display the
background on the preview screen.
7.1.3 Delete all
Use this menu to delete all stored channels. Select Delete All with p/q and press OK. The receiver
asks you to enter the pin code. (DEFAULT PIN: 1234). Inside the conrmation window select Yes with
tu and press OK to delete or select No to cancel.
Warning! The Delete all function will permanently delete all current channels and all
favourite lists from your receiver, and you are not able to leave the menu
until you search for channels again.
7.1.4 Rename Favourite list
This menu allows you to personalize the names of the 8 available favourite lists.
Use p/q to select Rename Favourite List from the Edit Channel Menu and press OK to proceed.
The names of all groups are now displayed. Select a favourite group with p/q and press OK to edit
its name. A text eld will now pop up at the right of the screen. Use tu p/q to select characters
and enter them with OK. When you have nished editing, press BLUE to save the changes. When all
changes have been made, press twice to leave this menu.
7.2 Installation
7.2.1 Channel Scan
Use p/q to select Installation, press OK or u to advance.
Use p/q to select Channel Scan and press OK to enter.
Use tu to toggle between available scan modes: By Channel and By Frequency.
If By Channel is selected, use p/qtu to select Channel No Symbol Rate and Scan QAM. If
Network Search is set to On, all channel belonging to the network of your operator will be found,
according to NIT information provided in the signal of the operator.
If By Frequency is selected, use p/qtu and 0 ~ 9 to select Frequency, Symbol Rate and select the
correct Scan QAM parameter. Highlight Search and press OK to start scanning. Newly found channels
will be added to the channel list.
If Network Search is set to On, all channel belonging to the network of your operator will be found,
according to NIT information provided in the signal of the operator.
NOTE: Obtain technical data about your cable-operator base channel from
your operator and start a network search from there to nd all channels
belonging to the network.
7.2.2 Auto Scan
Use p/q to select Installation and press OK or u to advance.
Select Auto Scan with p/q and press OK to enter.
Select your country and network.
Use p/q to highlight Search. Now press OK to start auto scan.
To Next Page
Loading...
