THOMSON THC301 - Page 18

14
will be asked to conrm. Selection above 576i is only applicable on HDMI
output.
Aspect Mode: Use this option to select the aspect ratio of your TV and the preferred
conversion method. The options are: Auto (automatic detection of aspect
ratio), 4:3PS (Panscan) (Displays 16:9 widescreen broadcasts full screen on
your 4:3 TV), 4:3LB (letterbox) (black bars on top and under the picture on a
4:3 TV) and 16:9 (use this setting for 16:9 TV sets).
Digital Audio Output: Toggles between PCM and Bitstream output. When PCM is selected, all
digital audio will be converted to stereo audio. Bitstream enables you to
listen or transfer Dolby® Digital/Dolby® Digital Plus* audio to the TV via
HDMI or to a Home entertainment system (for example) through coaxial S/
PDIF.
NOTE: Dolby® Digital Plus* is only available on the HDMI output.
*Dolby and the double-D symbol are registered trademarks of Dolby Laboratories
7.3.3 Local Time Setting
Here you can set up your region and time zone.
Region: Use tu to select the region you live in.
GMT Usage: Set to By Region for broadcaster dened time, User Dene to select manual
a GMT zone or to O to input time and date manually.
GMT Oset: Allows you to adjust your time zone. This option is only available when GMT
Usage is set to User Dene.The GMT Oset range is "-11:30 ~ +12:00",
increasing by half hours progressively. The cities matching the set GMT
Oset are displayed at the bottom of the screen.
Summer time: Select On to add one hour for summer time.
Date: Date and Time settings are available only when GMT Usage is set to O.
Use the 0~9 buttons to enter the date. Press  to proceed.
Time: Date and Time settings are available only when GMT Usage is set to O.
Use the 0~9 buttons to enter the time. Press  to proceed.
7.3.4 Timer Setting
This menu allows you to set up to 8 timed events for recording or waking up the receiver.
Use p/q to select Timer Setting from the System Setup menu and press OK to enter.
The receiver will display a list with 8 timers, followed by their respective status. Select the timer you
wish to set or change with p/q and press OK to proceed.
The timer setup menu will now be displayed.
The following settings are available:
Timer Mode: Choose between O the timer is inactive, Once, Daily (the timer will be
executed every day, same time) or Weekly (the timer will be executed every
week, same day, same time) and Monthly (the timer will be executed every
month, same day, same time).
Timer Service: Choose between Channel (the timer will wake up the receiver) or Record
(Timer will start recording the scheduled event).
Wakeup Channel: Use tu to select the channel the timer will wake up with.
Wakeup Date: Use the 0~9 buttons to enter the date for the timed event.
On time: Use the 0~9 buttons to enter the starting time.
Duration: Use the 0~9 buttons to enter the duration of the timer.
When all settings have been made, use p/q to move the highlight to Save and press OK to conrm.
To quit the timer without saving your settings, move the highlight to Cancel.
7.3.5 Parental Lock
This menu allows you to protect the installation menu and/or channels with a PIN code. You can also
enter a new PIN code in the Parental Lock menu.