P8
OPERATION
The volume can be adjusted with the V+/V- buttons. This is also possible in ALL menus which
present TV picture in background. In viewing mode you can also use the
t/u buttons.
Additionally you can ! your receiver in ALL menus which present TV picture in background.
The PG+/PG- enable you to scroll page wise in all list modes to make your channel or other
selection as comfortable as possible.
NOTE: 5 minutes after switching the receiver to standby, it will enter the deep sleep mode. Within
this time the receiver is able to start up quickly. Starting up from deep sleep takes approx. 1 min.
6.0 OPERATION
In viewing mode, several features are available to make watching TV a true pleasure. This
chapter describes these features. Please also read chapter 7.0 to get familiar with the menu of
your new receiver.
6.1 Changing channels
Your new receiver is equipped with three ways to change channels.
1. Via direct access
2. Via the channel list and
3. Via the P+/P- or
p/q keys.
6.1.1 Direct access
To gain direct access to a certain channel, simply input its number with the 0~9 buttons on the
remote control. Channel numbers can be up to four digits long. Entering a number with less
than four digits is possible. After entering the desired channel just wait a few seconds and your
receiver will switch to the selected channel.
6.1.2 Channel list
Press OK in viewing mode to display the Channel List. Use p/q or PG+/PG- in the Channel
List to highlight your channel of choice and press OK to switch to the highlighted channel.
The Channel List is equipped with a filter function to find your favourite channels easier. While in
the Channel List, press RED. An alphabet banner will now be displayed. Use
p/q or P+/P- to
select the first letter of the desired channel and OK to confirm. All channels beginning with the
chosen letter will now be displayed.
The following keys are available in the Channel list and viewing mode:
TV/R: Toggles between TV and radio channels, in channel list changes
the list mode.
LIST: Opens the satellite list selection in viewing and list mode.
FAV: Displays the favourite list selection in both modes.
6.1.3 Using the P+/P- keys
P+ or p will switch to a higher channel.
P- or
q will switch a lower channel.
6.2 Info banner
At any time during viewing mode you can press the button to get info about the current
channel and programme*. For the current programme info use the
t/u buttons to change
between the NOW and NEXT event info. Press
twice to see technical details about the current
channel. The technical info might help you in case of reception or similar problems to see if the
channel provides Audio/Video PIDs and if the signal is of sufficient quality and strength. Press
once more to remove it again.
* Programme information is displayed whenever available. Availability depends on the
broadcaster.
To Next Page
Loading...
