MAIN MENU
P13
English
After all settings are adjusted following to your preference, choose Save with p/q and press
OK. The receiver returns to the menu.
7.1.4 Parental Lock
This menu enables you to define and edit your PIN code, set Installation or Parental Lock.
Choose the desired setting with
p/q and press OK to list the possibilities up or use t/u to
change the value of the highlighted setting.
Please also carefully read the displayed instructions for each screen which will help you adjust
the settings correct and easily.
Actual PIN Code: Use the 0~9 buttons to access this menu options below. Enter the
(DEFAULT PIN: 0000) in case you have not changed previously.
Parental Lock: Use
t/u to select ON or OFF. Parental Lock allows you to prevent
children from watching adult channels in case these channels support
EPG respectively submit EPG based parental rate for your country. In
below adjust the Parental Rate accordingly.
Installation Lock: Use
t/u to select ON or OFF. Installation Lock allows you to lock the
access to your Installation settings and channel edit menus.
Parental Rate: Use
t/u to change these settings. Following rates are available:
Unblocked, 6+, 10+, 12+, 16+, 18+ or All Blocked. Depending on the
adjusted setting you will have to enter your PIN code when switching
through channels which support EPG respectively submit EPG based
parental rate.
Not rated content: Use
t/u buttons to select Blocked or Unblocked. In order to block or not
block the channels with PIN code before decoding, where the EPG based
parental rate not broadcasted.
New PIN Code: Use the 0~9 buttons to enter your desired PIN Code.
Confirm PIN Code: Use the 0~9 buttons to confirm your new entered PIN code.
Once all settings are made, press EXIT/SORTIE to leave the Parental Lock menu. When
returning to viewing mode the receiver will inform with a message that it saves your settings.
NOTE: If you are using the Parental Lock function NOT set to Unblocked then all FTA channels
which support EPG respectively submit EPG based parental rate will require to enter your PIN Code
(DEFAULT PIN: 0000).
7.1.5 Factory Reset
A factory reset will restore your receiver to the factory default settings. It will delete all settings
and channels. To reset the receiver, you have to enter your PIN code (DEFAULT PIN: 0000),
then use
p/q to select OK to execute or Cancel to return to the menu. Afterwards the receiver
will restart with the First Time Installation.
WARNING: A factory reset will permanently delete all your personal settings, timers and stored channels.
Please consider this before you perform a factory reset. In case you want to backup your settings before,
please refer to chapter 7.2.2 Backup to USB device!
7.2 Update & Info
This menu allows you to check information about your current Software, create a backup
of your channels, load a backup into the receiver and update the receiver via USB or OTA
(download via satellite). It consists of the following sub-menus: Receiver Information, Backup
to USB device, Backup from USB device, USB Software Update and OTA Software Update.
Choose the desired sub menu with
p/q and press OK to advance. For Backup to USB device
and Backup from USB device these functions will be executed by pressing OK directly.
To Next Page
Loading...
