P4
YOUR RECEIVER
7. HDMI To connect to the HDMI input of your TV set using a good quality
HDMI cable
8. Power switch To switch ON or OFF power of your receiver
9. DC POWER To connect to the original included main power adapter (Input 110
~240 V 50~60 Hz/ Output 12 V DC
2.4 Remote Control Unit
Fig. 3.
1. FAV Opens the favourite group selection
2. q Turns the receiver On/Standby
3. TV/R Toggles between TV and RADIO mode
4. 0~9 Channel selection or value input
5. PG-/PG+ Scroll page wise in all lists
6. BACK Switches between the two last watched channels
7.
Shows the actual channel information (2x technical info)
8.
p/q Menu Off: Change channel to previous/next.
Menu On: Moves the cursor up/down.
9.
t/u Menu Off: Increases/decreases the volume level.
Menu On: Change settings for specific Menus and for navigation
10. OK Menu Off: Displays the current channel list.
Menu On: Opens the highlighted setting
11. MENU Opens the main menu and from main menu you will get one step
back
12. EXIT/SORTIE Exits from the menu, sub-menu or cancels actions
13. GUIDE Shows the EPG (Electronic Programme Guide) in TV mode
14. V+/V- Increases/decreases volume in all modes
15. ! Mutes audio output of the receiver in every mode
16. P+/P- Programme +/-
17. SUB Shows the list of subtitle languages if available*
18. TXT Opens the Teletext if available*
19. AUDIO Opens the list of audio languages and settings
20. LIST Shows the satellite selection in viewing mode
21. OPT Opens the settings for TV format, aspect ratio and resolution
22.
In viewing mode changes the resolution
23. : No function
24. 5/6 No function
25. " No function
26. 4 No function
27. 1 No function
28. 2 No function
29. 3 No function
30. RED In Menu for specific functions.
31. GREEN In Menu for specific functions.
32. YELLOW In Menu for specific functions.
33. BLUE In Menu for specific functions.
2.5 Installing the Batteries
Fig. 4
To Next Page
Loading...
