P12
MAIN MENU
Once all settings are made, press EXIT/SORTIE to leave the System Settings menu. When
returning to the viewing mode the receiver informs with a message that it saves your settings.
7.1.3.1 HDMI
In this submenu you can set following parameters:
TV Ratio: 16:9 or 4:3, depending on the kind of your TV set.
Conversion: Letterbox, PanScan or Combined, to choose the preferred picture format.
Video Output: Only selectable for Scart
Resolution: 576p, 720p or 1080i, to adjust the optimum resolution your TV set
supports.
HDCP: ON or OFF, please see the Note below.
NOTE: HDCP (High Definition Content Protection) is set to ON per default as nowadays all TV sets with
an HDMI connector support HDCP. In case you have problems with the HDMI connection you can use the
Scart setting to deactivate HDCP, which will allow to watch via HDMI without problems. Consider that movies
which are broadcasted with an extra content protection might not be shown when HDCP is set to OFF.
7.1.3.2 SCART
In this submenu you can set following parameters:
TV Ratio: 16:9 or 4:3, depending on the kind of your TV set.
Conversion: Letterbox, Pan &Scan or Combined, to choose the preferred picture
format.
Video Output: RGB or CVBS, depending on what your TV set supports, but for Scart we
recommend RGB.
Resolution: Only selectable for HDMI
HDCP: ON or OFF, please see the Note above.
After all settings are adjusted following to your preference, choose Save with
p/q and press
OK. The receiver returns to the menu.
7.1.3.3 Select Audio Language
In this submenu you can set up to four preferred audio languages:
First Language: Either use OK for a list with all available languages or use
t/u to select
the desired one.
Second Language: Either use OK for a list with all available languages or use
t/u to select
the desired one.
Third Language: Either use OK for a list with all available languages or use
t/u to select
the desired one.
Fourth Language: Either use OK for a list with all available languages or use
t/u to select
the desired one.
The receiver will automatically switch to the preferred audio language whenever available. In case
the first language is not available the second language will be taken into account and in case the first
and second languages are both not available the third language will be taken and so on.
After all settings are adjusted following to your preference, choose Save with
p/q and press
OK. The receiver returns to the menu.
7.1.3.4 Select Subtitle Language
In this submenu you can set up if you want to display DVB subtitles and select your language
accordingly:
Subtitle Display: Use
t/u to select ON or OFF depending on DVB subtitle display being
preferred or not.
Subtitle Language: Either use OK for a list with all available languages or
t/u to select the
desired language.
Whenever available, DVB subtitles will be displayed in the selected language.
To Next Page
Loading...
