6
9. INFO Press to display channel number/name and current/coming
information. Press twice to display detailed event information.
10. EPG Viewing mode: Displays the EPG (Electronic Program Guide)
11. pq Switches to the next/previous channel in viewing mode, switches to
the next/previous page in channel list or moving the highlight up/
down in the menu
12. OK Viewing mode: Displays the channel list. Menu: activation of the
highlighted item
13. t u Decreasing/increasing the volume level in viewing mode/navigating
through the menus/changing values of settings in a menu
14. MENU To open the main menu in viewing mode or to go one step back in
the menu
15. Cancellation of current process/exit from main menu to viewing
mode
16. VOL+/- Increases/decreases the volume level in TV mode
17. P+/P- Jumps 10 places up or down in channel list or any other list.
18. LIST Displays the channel list.
19. CH+/- Channel up/down
20. OPT Quick Screen setting
21. TEXT To open Teletext if available on the current channel.
22. SUB To select subtitles language out of available ones on the current
channel
23. Mail list
24.-31. No function
25. Stops playback of multimedia les
26. RED Flexible functions in OSD menu and Teletext.
27. GREEN Flexible functions in OSD menu and Teletext.
Changes the picture resolution in viewing mode.
28. YELLOW Flexible functions in OSD menu and Teletext.
Changes the picture Aspect Ratio in viewing mode.
29. BLUE In viewing mode: displays the schedule menu for easy setup timers;
Flexible functions in OSD menu and Teletext.
2.6 Installing the batteries
Fig. 5
Remove the battery cover from the remote control and put 2x AAA size batteries inside the
compartment.
The diagram inside the battery compartment shows the correct way to install the batteries.
1. Open the cover
2. Install batteries
3. Close the cover
NOTE: The batteries should not be recharged, disassembled, electrically short-
circuited, be mixed or used with other types of batteries.
2.7 Using the remote control
Fig. 6
To use the remote control, point it towards the front of the digital receiver. The remote control has a
range of up to 7 metres from the receiver, if properly aligned towards the IR eye on the front panel.
The remote control will not operate if its path is blocked.
Note: Sunlight or very bright light might decrease the sensitivity of the remote
control.
To Next Page
Loading...
