THOMSON THS844 - Output Settings

14
If the language is not available, the default programme language will be
used.
2nd Audio Language: The receiver will use this language if the rst language selection is not
available
Subtitle Type: Choose your preferred subtitle type between Normal and Hard of hearing.
Subtitle Display: Set to On to enable the display of subtitles, to disable set to O.
1st Subtitle Language: Select the preferred subtitle language for watching TV channels.
This setting allows you to dene the default subtitle language. Digital TV
allows the operator to transfer subtitles in one or more languages. In the
viewing mode you can change this selection to a more suitable variation,
as described in chapter 6.5. If the language is not available, the default
language will be set.
2nd Subtitle Language: The receiver will use this language if the rst subtitle selection is not
available.
7.2.2 Output Settings
This submenu allows you to set the output parameters of the receiver according to a connected TV
set and to the audio amplier (if applicable).
HDMI Resolution: Select the screen resolution according to the characteristics and supported
modes of your TV set. Available options: 576i, 576p, 720p, 1080i and
1080p.
Note: Experiment with the settings to nd the options that suit the best for you.
You can change the parameters of the viewing mode by pressing OPT.
Note: Do not forget about the possibility to control the screen format from the
menu of your TV (depending on your TV device).
Aspect Ratio: Select an aspect ratio depending on your TV set screen format. Available
options: 4:3 or 16:9.
Aspect Conversion: Change the aspect conversion. Available options: Pan&Scan, LetterBox,
Combined and Ignore.
Note: If the receiver is connected to a TV with 4:3 aspect ratio, the most
recommended mode is LetterBox. In this mode the video in 4:3 format will
not be converted and the 16:9 format will be converted to display in full
size and without geometric transformations (displays full screen width and
top and bottom of the screen shows black horizontal bars).
Other options available for conversion of 16:9 video format:
4:3 TV Pan&Scan Displays full screen and high size, but the left and right sides of the screen
are cut.
Combined Cuts left and right sides of screen to a minor extent and displays black
horizontal bars at upper and lower parts.
SCART Output: This setting is only relevant when the receiver is connected to the TV set via
SCART. Select RGB for the best picture quality or CVBS if your TV does not
support RGB.
HDCP: Available options: On or O, please see the note below.
Note: HDCP (High Denition Content Protection) is set to On to default as
nowadays all TV sets with an HDMI connector support HDCP. If you face
problems with the HDMI connection, you can deactivate HDCP, which
allows watching via HDMI without problems. Please consider that movies
which are broadcasted with an extra content protection might not be
shown when HDCP is set to O.