TSC 80e TRANSFER SWITCH CONTROLLER
PM091 Rev 1 09/02/27 Thomson Technology
24
3.6.1.8.ENGINE START DELAY SETTING
The LCD screen displays the Engine Start Delay Timer, displayed are: active
timer value and programmed time delay setpoint in the TSC 80e controller.
3.6.1.9.ENGINE WARMUP DELAY SETTING
The LCD screen displays the Engine Warm-up Delay Timer, displayed are:
active timer value and programmed time delay setpoint in the TSC 80e
controller.
3.6.1.10.ENGINE COOLDOWN DELAY SETTING
The LCD screen displays the Engine Cooldown Delay Timer, displayed are:
active timer value and programmed time delay setpoint in the TSC 80e
controller.
3.6.1.11.NEUTRAL DELAY SETTING
The LCD screen displays the Neutral Delay Timer, displayed are: active timer
remaining value and programmed time delay setpoint in the TSC 80e controller.
3.6.1.12.UTILITY UNDER VOLTAGE SETTING
The LCD screen displays the programmed Utility Voltage under voltage sensor
setpoint value and the associated dropout % in the TSC 80e controller
(percentage is based on nominal voltage level selected in System
Configuration).
3.6.1.13.UTILITY RETURN DELAY SETTING
The LCD screen displays the Utility Return Timer, displayed are: active timer
value and programmed time delay setpoint in the TSC 80e controller.
3.6.1.14.AUTO EXERCISE MODE STATUS
The LCD screen displays if the Auto Exercise mode is currently enabled or
disabled. When it is enabled, the remaining time to test is displayed.
3.6.1.15.GENERATOR MODE STATUS
The LCD screen displays the present operating mode the generator is in.
3.6.1.16.UTILITY FAULT STATUS
The LCD screen displays the current status of the Utility Supply. The following
statuses can be displayed:
Normal
Utility Limit Switch Fail
Utility Switching Device Failed
To Next Page
Loading...
Need help?
General
