THOMSON TSC 80E - V2.2 - System Statistics

TSC 80e TRANSFER SWITCH CONTROLLER
PM091 Rev 1 09/02/27 Thomson Technology
50
• Normally Closed- TB2 –15
• Normally Open- TB2 –16
Note: The ATS will be factory wired for programmable output #4 as Load on
Generator. If a different function is programmed, the ATS relay installed will
need to be re-assigned accordingly.
4.6.10.5.Programmable Output #5
Programmable output #5 corresponds to the following output relay contacts:
• Common- TB2 –11
• Normally Closed- TB2 –12
• Normally Open- TB2 –13
•
Note: Factory default setting for programmable output #5 is Load on Utility. If
a different function is programmed, the ATS relay installed will need to be re-
assigned accordingly.
4.6.11.SYSTEM STATISTICS
4.6.11.1.Xfer Total
Displays Total Number of Transfers
4.6.11.2.Monitoring Time
Displays Total Number of Hours the Controller is energized
4.6.11.3.Load on Gen
Displays Total Number of Hours Load is on Generator
4.6.11.4.Load on Utility
Displays Total Number of Hours Load is on Utility
4.6.11.5. Xfers Util Fault
Displays Total Number of Transfers due to a utility failure