Appendix D
70 HA0363T Rev D Jan 2017
SetDispMode Sets the GUI display mode.
SetHomeParams Sets the homing sequence parameters.
SetHWLimSwitches Sets the limit switch configuration settings.
SetIndicatorLEDMode Sets the front panel indication LED operating modes
(Cube drivers).
SetJogMode Sets the jogging button operating modes.
SetJogStepSize Sets the jogging step size.
SetJogVelParams Sets the jogging velocity profile parameters.
SetKCubePanelParams Sets the operating parameters of the velocity wheel
on the top panel
SetKCubePosTriggerParams Sets operating parameters used when the triggering
mode is set to a trigger out position steps mode
SetKCubeTriggerParams Sets the operating parameters of the TRIG1 and
TRIG2 connectors on the front panel of the unit.
SetMotorParams Sets the motor gearing parameters.
SetPositionOffset Sets the motor position offset.
SetPotParams Sets the velocity control potentiometer parameters
SetRelMoveDist Sets the relative move distance.
SetStageAxisInfo Sets the stage axis parameters.
SetVelParams Sets the velocity profile parameters.
ShowSettingsDlg Display the GUI Settings panel.
StartCtrl Starts the ActiveX Control (starts communication
with controller)
StopCtrl Stops the ActiveX Control (stops communication
with controller)
StopImmediate Stops a motor move immediately.
StopProfiled Stops a motor move in a profiled (decelleration)
manner.
Properties
APTHelp Specifies the help file that will be accessed when the
user presses the F1 key. If APTHelp is set to 'True',
the main server helpfile MG17Base will be launched.
DisplayMode Allows the display mode of the virtual display panel
to be set/read.
HWSerialNum specifies the serial number of the hardware unit to
be associated with an ActiveX control instance.
To Next Page
Loading...
General